It would seem that the concepts of MTL and the grid are almost incompatible. But the developers of Damn Vape think very differently, and combine these two concepts together in their next novelty. Well, what can you do – these guys like experiments, we’ll try and we’ll give a damn about this innovation – Intense Mesh MTL RDA.
Parameters
Case material: stainless steel / plastic Atomizer
Type: RDA
Capacity: almost 3ml
Diameter: 24mm
Height: 34mm with drip type / 24mm without drip type
Connector: 510, pin gilded
Weight: 32 / 39g
Appearance – well, that appearance of Damn Vape is the most ordinary. As for me, the novelty has practically no memorable decor element. Well, almost none – maybe an extra plastic dome. In general, the design is calm – no frills and vulgarity – better so. Dimensions are naturally modest – the truth is, the diameter, as you can see, is not quite a cigarette.
The drip type is made of plastic, landing is 510th. The area below it is approximately 10.7mm. On the inner surface there are bevels that hold condensate. So I did not find any problems with this. Internal processing of the dome under the cone. We’ll talk about blowing a little later.
It’s not that they fall off by themselves when turning the drip tip in vape always online, but the origins should be made denser. By the way, this dome is sometimes inclined to solder with condensate (uncritically), probably due to the fact that this same treatment is absent at the drip type inlet.
Related products you may be interested:
smok fetch kit usa
smok rpm40 rba usa